(The reason why you should NOT add the entire 5.8 quarts is because there is still some residual oil in the engine and it's not good to over fill. Remove oil cap and input 5.25 quarts of oil using the funnel. DO NOT over tighten! Tight to the proper torque spec (24 N/m) or if you do NOT have a torque wrench tight a 1/4 turn past hand tight.Ĩ. ![]() Install drain plug with new washer and tighten to the proper torque spec (24N/m) or 1/2 turn past finger tight.ħ. Replace oil filter cartridge and replace the three o-rings (See Photo 4 below) Coat the new o-rings with some new oil.Ħ. Remove oil filter cartridge (this may take a little force) and three rubber o-rings. As the oil is draining out, remove the oil filter from engine bay.ĥ. Located oil pan drain plug and remove plug with 1/2" socket (See Photo 3 below) Make sure you have the oil collection pan under drain, because the oil will come flowing out fast.**Ĥ. Jack up the car and remove plastic engine covers on the bottom of the car with 8mm socket.**ģ. This will allow the oil in the filter to flow back to the oil pan. Locate the oil filter and slightly loosen it, DO NOT remove it at this time. ![]() My dealer provided a new drain plug washer the filter.Ģ. If you suck the oil out these tools are not needed.ġ. * Optional tools, only needed if you plan to drain the oil. It might be the similar for other C-class models. This only applies to 2001-2005 (I-4 supercharged engines) or w203 chasis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |